Color-coated sheet roof is a new type of panel, which is considered to be the most ideal material for modern buildings, and has a relatively long life. There are many precautions for installing the color-coated roof as the bottom plate. Professional construction masters are required to install it. The aluminum-magnesium-manganese roof panel is made of aluminum-magnesium-manganese plates. This type of material will not corrode even if it is used for a long time Under normal conditions, it can be used for 40 years, so as not to affect the effect of future use. The specific installation precautions are as follows:

      Before installation, it is necessary to clean up the pollutants on the roof of the color-coated panel to avoid corrosion of the panel. In addition, pay attention to the flatness of the panel during installation, and there must be no bending or deformation. The roof of the color-coated board overlaps a wave crest, so it has been recognized by many users. The entire system of the aluminum-magnesium-manganese roof panel adopts the mechanized seaming mode, which can avoid the occurrence of water leakage and has a good drainage system, especially in heavy rain weather, it can discharge the water in time. It can avoid the huge pressure caused by the extrusion of water, and can prevent the deformation of the project. This will make it stronger and prevent water leakage. It is best to anchor reliably, keep the installation flat, and leave no gaps between the boards.

      Color-coated sheet roof is a new type of panel

The installation of the color-coated sheet roof and floor needs to be from high to low, and the lightning protection system design is familiar. The roof board can be used as a lightning receptor alone, and there is no need to install a lightning protection belt. It can also be used in conjunction with an avoidance belt or a lightning rod to form a safe multiple lightning protection system; the installation method is from the middle part to the edge, and the overlapping method is from low to high. After the floor installation starting line is installed, select self-tapping screws to lock both ends, and then install the second board. The roof of the second color-coated board needs to be installed, and the roof should be marked to check whether there is any deviation in the board. It needs to meet the design requirements. If it cannot meet the needs, adjust it and then fully tighten it. After the installation is complete, pay attention to check whether there are any omissions. If the fastening is not enough, there will be rain leakage, so you must pay attention.